Monday, March 9, 2015

New project

So, once again, I have started another project. Talking to some guys at work, and one has decided to take the plunge and get some chickens. Not just a few, but he's going all in (well, not literally, but still) and get ten (!) chicks, and raise them for eggs. Naturally, talk turned to coops, and he asked if I could build him a coop. After doing some research, I determined I could, and we discussed what he would need; we decided on a 4x8 coop, raised rather a walk-in.

So, I got to work. I started with the frame, using 2x4x10s, cut down to 9'. The coop itself will be 4x8, and the extra foot will be for the roosting boxes.



Next, I added two more studs so that the floor will be well supported; although this shouldn't end up being extremely heavy, it isn't going to be light either. Once the floor frame was done, I used some 2x4s cut two feet long as legs. Since this is being built in the barn, I felt it would be best to build it near the door, out of the elements, but easy to load onto a trailer when it's done.



Now that the framing and legs were ready, I turned them right-side up, and attached the floor. For this, I used a single sheet of plywood; I have to admit that the size of the coop is perfect, because no cutting was necessary to fit the floor on the frame. You can also see the second piece of plywood that is going to be for the nesting boxes. After attaching the floor, I put on a sealer coat, to make cleaning it easier.



At this point, I framed the long walls, although I call them the front and back. The taller frame is the front, the shorter the rear; the slope on the top of the frames is sloped for the corrugated metal that will be used for the roof. On the front frame, there is the framing for the double door that will be used for cleaning the coop. There is also a 2" opening running the length of the wall, for ventilation.

On the rear wall framing, there is another opening running the length of the wall for ventilation, although this one is 4". There is also framing running the length of the wall, one foot above the floor. There will be two doors there, also used for cleaning, under the roost. That roost will run the length of the coop, and will have four 18"x24" pans under it, to make it easier.


This is where I am now; I started on Saturday, and will hopefully be done by this next weekend. We'll see, but my progress will be documented here...

No comments:

Post a Comment