Well, I'm calling it a truck bench, because it's a bench with a truck tailgate as the backrest. I saw one recently, thought it was a cool idea, and decided that I was going to make one for myself. I was already going to a junkyard (excuse me, Pull A Part) to get something, so I went looking for a truck tailgate. I found one that I was okay with, but decided to check just a few more on my way out, and found one that I thought was perfect. Here it is, after I've sprayed it with a flat clear coat to make sure it lasts longer in whatever weather it sees. I'm guessing the previous owner of the truck painted it himself, but I thought it fit just right, even though the paint job isn't the greatest...

It really didn't take all that much lumber. The legs are 4x4's, the seat is 2x6's, and the frame, arms, and back supports are 2x4's. I didn't have a blueprint, so I ended up using more wood than I actually needed to, but that's the problem with just winging it, as I was doing in this case. I suppose that if I were a better woodworker, with more experience, I wouldn't run into issues like this, but as far as I know, there's only one way to get that experience. Anyway, here is the wood before I started, just cut to size.
This is all of what I should have needed; as I said, the wood used ended up being a little bit more. Since the bench is going outside, I felt as though I needed to do something to protect the wood; I decided that staining it was preferable to painting it, so that is what I did.
 |
| Note the Shamrock shake that Lisa brought me :) |
I did measure the wood right, and notched the front seat board correctly, but forgot that there was supposed to be a slight gap between the front leg and that notch, so that the legs were closer together than they should have been. Enough that the tailgate didn't quite fit in, anyway. That didn't turn out to be a big problem, since I was able to cut and chisel out enough to fit in the tailgate. In the end, that worked out better, since the back braces for the tailgate (one upper, one lower) lock the tailgate into position without having to drill holes for bolts to do the same thing.
You can see that the backrest is angled somewhat, so that it is more comfortable to sit in. Although I suppose that using the other side of the tailgate might be an idea, since it isn't angled, I liked the idea of having the name facing out better.
Another project done. That's a good feeling, and one that I need to work on having more often... lol
No comments:
Post a Comment